The roofing
Starter strip, field shingles and ridge caps, or the panels and trim for a metal roof with fasteners placed where they belong.
A roofer in Nutley can install a new roof in the proper sequence: drip edge, ice and water shield, underlayment, starter strip, flashing, vents and then the roofing itself, whether the roof is going on a stripped deck or as a permitted overlay. Call (973) 858-1824 to reach a local roofer.
Most early roof leaks are installation problems, not material problems. High nailing lets wind peel shingles off, a skipped kickout flashing sends water down into the wall and a poorly cut valley lets water work sideways under the shingles. By the time they show up, the stain is already on the ceiling.
The first decision is what kind of roof to install. Architectural, or dimensional, asphalt shingles are the most common choice on houses, with thinner three-tab shingles still used on some homes and sheds, while standing seam or exposed fastener metal, concrete or clay tile and slate each need their own methods and fasteners. Pitch, the weight the framing can carry and the look you want all narrow down the choice.
It helps to bring a few details to the first conversation. Say whether the job is a tear-off, an addition or new construction, and whether you have a material or color picked out.
If the problem goes deeper than it first looked, a Nutley roofer may also recommend roof replacement or shingle roof installation.
Dealing with this in Nutley, NJ right now? Call (973) 858-1824 and describe the problem to a roofer who works in Nutley.
Call nowA roof goes on from the bottom of the system to the top.
Before installation, the crew walks the decking and replaces soft or damaged sections. On an overlay, the old shingles must lie flat, and any badly curled ones are cut back or replaced.
The eaves get drip edge and a band of ice and water shield, and every valley gets a full-width strip. Codes in colder areas often require the ice barrier to reach a set distance inside the exterior wall.
Synthetic underlayment or felt covers the rest of the deck, lapped so each row sheds over the one below. Most crews now use synthetic underlayment, which holds up better to foot traffic and weather.
Step flashing is woven in with each course along sidewalls, counter flashing covers it at masonry, kickout flashing sits at the bottom of each wall line and new pipe boots go over every vent. Reused or caulk-only flashing is one of the most common installation shortcuts.
Starter shingles seal the first course, and each shingle is nailed through the marked nail line, not above it. Valleys are finished as open metal, closed cut or woven, depending on the material and the plan.
The crew opens a slot at the ridge for a ridge vent, or installs box vents, and finishes with cap shingles. Balanced intake and exhaust keep the attic drier in winter and cooler in summer.
Starter strip, field shingles and ridge caps, or the panels and trim for a metal roof with fasteners placed where they belong.
New flashing at every wall, chimney and vent pipe so the weak points match the new roof.
An exhaust system sized for the attic for a drier attic all year.
Ice and water shield at the eaves and valleys, with underlayment over the rest of the deck guards the deck if ice dams form.
Metal edges around the whole roof finishes the edges cleanly.
Whether the roof is going on a new house, an addition or a stripped deck, the installation steps are largely the same. Tie-ins between new and old roofs are a common leak point, so they need full ice barrier and careful flashing. Ask the roofer how the tie-in will be handled and whether any of the existing roof will be replaced to make it work.
The installation should follow the roofing maker's printed instructions, which spell out nailing, underlayment, slope limits and ventilation. Good questions for a Nutley roofing contractor include nail count, underlayment type and the ventilation plan. Vague answers about the hidden layers are worth noticing.
A roof overlay installs a new layer of shingles directly over one existing layer instead of tearing the old roof off. Building codes generally cap asphalt roofs at two layers, so an overlay is only possible on a roof with a single layer, and not over shingles that are badly curled, wet or sitting on soft decking. The appeal is less labor, less debris and a shorter job.
The trade-offs are real. The deck stays hidden, ice barrier cannot be applied directly to the wood and any wear in the old roof shows through the new one. When an overlay is proposed, ask how they confirmed there is only one layer and how the flashing will be handled.
Roof installation in Nutley runs from full tear-offs on older homes to brand new roofs on additions and new houses. Across Nutley and nearby places including Glen Ridge, Rutherford, North Arlington and Clifton, storms take the biggest toll on roofs that were installed with shortcuts, which is why the installation plan deserves as much attention as the material.
Need roof installation around Nutley? Call (973) 858-1824 for a Nutley roofer who serves the towns around it too.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Nutley, NJ have the roof checked in the fall and again after the snow melts.
Small roof problems caught early usually stay small repairs.
Local roofers see the same roofs and storm damage across Nutley and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (973) 858-1824
Replacing an aging roof with new underlayment, flashing, vents and roofing, with the old layers removed and the deck checked.
Learn moreNew shingle roofs built layer by layer on a sound deck, so the roof sheds water and handles wind from day one.
Learn moreMetal roof installation built around the right panel, finish and trim for the house, so the roof handles heat, wind and thermal movement.
Learn moreGetting new framing dried in fast and roofed to code, with flashing timed around windows and siding.
Learn moreLooking for something else?
See all roofing servicesCall now for Nutley roof installation and help in the towns around it.